• Equipment selection

    Installation works

    Start-up works

    Repair works

  • Safety and life-support systems

    Arctic model equipment

    Explosion-proof equipment

    Valve remote control





  • Ventilation and air conditioning systems

    Furniture and interior design

    Wall panels, carpeting

  • Trawling stations

    Ladders, ropes, anchors

    Refrigerator equipment

    Fish-searching equipment

    Fish-processing equipment

  • Drilling equipment

    Generator stations

    Position-control system

    Dwelling module installations





  • Logistics

    Customs and forwarding

    Consolidation and storage

    Supply control -Tracking system

  • Repair dock selection

    Design works

    Installation works

    Start-up works

    Repair works

    Ship survey

EVAPORATOR WT (Vaptreat, FWG Evap QC1, Ameroyal)

NEUTRAL, LIQUID PRODUCT FOR THE PREVENTION OF SCALING IN SEA WATER EVAPORATORS

• Product developed as part of the StarMarine Water Treatment Program.

• Prevents scale formation at temperatures up to 160°C.

• Reduces foaming and maintains optimum plant performance.

• Environmentally safe product with approval for use when distilling to potable water tanks.




Introduction

In the production of distilled water in seawater evaporators, there are many conditions which can cause scaling. In the evaporator, the seawater is heated to the required temperature and is then partially evaporated at atmospheric or low pressure; it then condenses and is collected as distillate. Since, however, the seawater contains large quantities of salt in solution it is understandable that the heating and evaporation will very rapidly lead to scaling of the heat transfer surfaces. The scale deposits build up and lower plant efficiency by severely impairing the transfer of heat. This in turn considerably reduces the output.  Scaling is prevented by the use of Evaporator WT.

If the product is used as part of the StarMarine Water Treatment program, production is monitored as part of a "Water Management" system which includes useful information on maximizing plant efficiency.

Directions for use

Evaporator WT is diluted with seawater and fresh water and is continuously injected into the evaporator. A dosage of 30 ml per ton of distillate is recommended for the prevention of scaling in seawater evaporators. The total dosage of Evaporator WT to be used depends on the capacity and the operating conditions of the evaporator.  The product should be injected via the evaporator inlet or the salt water supply line. The normal procedure is to use a dosing tank containing sufficient ready diluted Evaporator WT for 24 hours continuous operation.

Note: for the gradual removal of existing scale deposits, at least twice the normal dose must be used. Remove deposits of more than 2mm, with Descalex Liquid.

Dosing systems

Norta MIT can supply a gravity dosing system kit which includes a dosing tank, flow meter, pipes, valves and all fittings.

Properties

Light brown colored, neutral liquids. Miscible with salt and fresh water in any proportion. Odorless, non-flammable. Contains no volatile components; in practical terms, non-toxic when ingested in a single dose. Remains fully effectively up to 160°C. Does not corrode stainless steel, carbon steel, copper alloys, glass rubber, plastics, painted surfaces, aluminium and aluminium alloys.

Specific gravity (20°C)     : 1.06

Flash point                        : None

pH (1% solution)              : 7-9

BACK TO ANALOGUES LIST

Print Send enquiry
Send enquiry
Закрыть

Send Response

Protection from automated form filling
 
Please type in the symbols shown in the image above*


Send response
Закрыть

Send an enquiry

Protection from automated form filling
 
Please type in the symbols shown in the image above*